1.Safety Information
Appendix C: Line Fuse Replacement
The line fuse is in the plastic fuse box below the power line input on the rear
panel.
Warning: Disconnect the line cord at the rear panel and remove all test
leads connected to the instrument before replacing the line
fuse. Failure to do so could expose the operator to hazardous
voltages that could result in personal injury or death.
Use only the correct fuse type. Failure to do so could result in personal injury or
instrument damage.
Voltage Fuse
90 - 240 V AC 250 V, F1AL
To perform the line fuse replacement, follow these steps:
1. Turn o the multimeter, remove all measurement leads and other cables from
the instrument, including the power cord.
2. Use a at-blade screwdriver to remove the fuse box.
3. Replace the fuse with a new one, install it into the fuse box, and push the
fuse box back on to the rear panel.
To Previous Page
Loading...
