1. Make sure the wiring is safely inside the
outlet box as instructed in Step 5 -
Electrical Connections. To install the
canopy, slide the canopy up to hanger
bracket and place the key hole on the
canopy over the screw on the hanger
bracket, turn canopy until it locks in place
at the narrow section of the key holes. (Fig.
9) Align the circular hole on canopy with
the remaining hole on the hanger bracket,
secure by tightening the two set screws, lift
canopy cover and attach by turning
clockwise. Note: Adjust the canopy screws
as necessary until the canopy and canopy
cover are snug. (Fig. 9)
2. Blade Assembly & Installation (Fig. 10)
Using the supplied blade screws and blade
support plates, attach the blades to the
motor assembly by sliding blades through
blade slots. In some cases the metal washer
is permanently fixed to the screw head.
Ensure all screws are used for each blade.
DO NOT bend the blade arms when
installing the blades.
3. Attaching the Mounting Plate (Fig. 11)
Attach the mounting plate to the flange of the
motor by using the three (3) screws provided
that are preinstalled on the flange.
4. Attaching the Decorative Cover
(Fig. 12)
Attach the decorative cover mounting plate to
the mounting plate by using the three (3)
screws provided that are preinstalled on the
mounting plate. Raise decorative cover up
against decorative cover mounting plate and
secure it to the fan by turning clockwise
until snug. DO NOT OVERTIGHTEN.
A certain amount of wobble may be
considered normal, especially if the fan is
on a downrod long than 12".
6. COMPLETING THE INSTALLATION
Fig. 10
Fig. 12
Fig. 9
Outlet box
Hanger
bracket
Canopy
Canopy cover
Screws
Screws
Fig. 11
Blade support
plate
Blade slot
Blades
Screws
Screws
Flange
Mounting
plate
Screws
Mounting
plate
Decorative
cover
Decorative cover
support plate
To Next Page
Loading...