Need help?Do you have a question about the OxyGuard Handy Polaris TGP and is the answer not in the manual?
General| Category | Measuring Instruments |
|---|---|
| Model | Handy Polaris TGP |
| Temperature Compensation | Automatic |
| Salinity Compensation | Yes |
| Display | LCD |
| IP Rating | IP67 |
| Operating Temperature | 0 to 50 °C |
Shows pressures as percent saturation relative to air saturation.
Shows pressures as volume percentages relative to atmospheric pressure.
Hold the on/off button for 3 seconds to turn the device on or off.
Probe calibration is automatic, aligning oxygen and gas pressure sensors.
Accurate measurements require stable conditions; select 'Calibrate' to start.
Connect to a PC via the OxyGuard Polaris Link to transfer logged data.
Replace battery when 'Low Batt' appears; rechargeable batteries recommended.
Carefully unplug and replace the sensor element, ensuring the connection stud is clean.
Follow display prompts and drawings to renovate the DO sensor using new membrane.
To Next Page