Use “Log Values” to select what should be logged. The options are “Barometer”,
“Rest gases”, “oxygen mg/l” and “oxygen %Vol”. Press “OK” and choose “Off or
On” to select.
“Max Log ID” sets the number of groups of logs the memory is divided between.
Store all measurements made the same place (both one-shot and interval) Under
the same ”Log ID”. Each measurement has specific date and time information.
“Full log handling” lets you choose between over-writing (recycle) or stopping
when the memory is full.
“Erase Log” lets you do just that.
“Log Status” shows the present setting of the datalogger.
d) Date and Time Menu
Dette menupunkt har tre underpunkter:
Set Date and Time
Set Date Format
Show Date and Time
e) Calib precision
Here you can choose between
“Field” (recommended, factory setting)
“Normal”
“High”
If conditions are stable "Field" can give just as accurate calibration as "Normal" or
"High". “Normal” ensures very precise measurements, and ”High” is the most
sensitive. “High” needs very stable conditions indeed.
f) Information
This shows the software version and serial numbers of probe and instrument.
7) Show Log:
“Graph” will show the logged data as graphs
“Table” will show data as tables
You will be asked for the memory block ID number you want to see.
Choose “0” to see all ID’s.
To Next Page
Loading...