3/8” LP
33
3/8” LP
33
3/8” LP
33
3/8” LP
33
3/8” LP
33
3/8” LP
33
4. PREPARATION
Extension cord retainer
The cord retainer is used to “anchor” an extension cord (not
included) when it is connected to the power lead of the pole
pruner. It prevents the extension cord from being accidentally
disconnected from the pole pruner’s power lead or shaken loose
during use.
1. Make a loop with the extension cord (socket end of cord), push
it through the hole and secure over the hook.
2. Pull the extension cord to secure it in position over the cord
retainer.
3. Connect the extension cord to the power lead. Route the power
and extension cord away from the work area to prevent contact
with the chain.
Adjusting the telescopic length
1. To unlock the telescopic tube
collar, twist the collar in a
clockwise direction while
pointing the chain away from the
user. The locking and unlocking
directions are indicated on the
collar.
2. With the collar released, the telescopic tube can be pulled
forward out of the collar, thereby extending its reach.
3. To lock in the desired position, firmly twist the telescopic tube
collar in an anti-clockwise direction, while pointing the chain
away from the user.
Attaching the shoulder strap
1. Fasten the carabiner hook on the ends of the shoulder strap to
the shoulder strap retainers.
2. Wear the shoulder strap so that it lies over your left shoulder.
3. Using the strap adjuster on the shoulder strap, make
adjustments until you achieve the most comfortable working
and cutting position.
NOTE: If necessary you can adjust the position of the shoulder
strap retainer on the main tube. To do so, loosen the bolt and move
the shoulder strap retainer as required and then retighten the bolt.
Guide bar cover
The cover protects both the chain & bar when not in use. Simply
slide it off the chain & bar before use. Once finished operating,
place the cover back over the chain & bar.
Protective Clothing
Make absolutely sure to wear appropriate protective clothing and
equipment, such as close fitting protective pants, gloves, safety
shoes, safety helmet, hearing protection and safety goggles.
Wearing a safety helmet with a face guard will provide protection
against falling and recoiling branches.
To Next Page
Loading...
