Ozito EPP-751 - Operation; Starting and Stopping

3/8” LP
33
MIN
3/8” LP
33
MIN
3/8” LP
33
MIN
3/8” LP
33
3/8” LP
33
3mm gap is the
ideal tension
5. STARTING & STOPPING
OPERATION
EPP-751
Before each use
Before beginning work, inspect the pole pruner for damage to the
housing, the electrical cable, the chain and the guide bar. Never
use an obviously damaged machine
Oil tank
Check the fill level of
the oil tank. Also check
whether there is sufficient
oil available while working.
Never operate the pole
pruner if there is no oil or
the oil level has dropped
below the minimum oil
level mark in order to
prevent damage to the pole
pruner. On average, an oil
filling is sufficient for 10 minutes of operation, depending on the
duration of pauses and the stress.
Chain
Check the tension of the chain and
condition of the cutters.
The sharper the chain is, the easier
and more manageable the pole
pruner is to operate. The same
applies for the chain tension.
Check the chain tension at least
once every 10 minutes while
working in order to increase safety.
New saw chains, in particular, tend to have a higher degree of
elongation.
WARNING! FAMILIARISE YOURSELF WITH
SURROUNDING HAZARDS SUCH AS POWER LINES,
PHONE LINES, METAL FENCES AND OTHER OBJECTS
THAT COULD BE IN YOUR PATH. FAILURE TO DO SO
COULD RESULT IN ELECTRICAL SHOCK, PERSONAL
INJURY OR DAMAGE TO YOUR POLE PRUNER.
Before starting the pole pruner
- Remove the guide bar cover.
- Make sure you have a secure and balanced footing.
- Make sure the bar & chain is not touching the ground or any
other objects.
- Hold the unit with both hands: one hand on the rear handle and
one hand on the extension pole soft grip.
- Make sure you are wearing the appropriate protective clothing.
WARNING! TO REDUCE THE RISK OF ELECTRIC SHOCK,
THE USE OF A RESIDUAL CURRENT DEVICE RATED AT
30mA OR LESS IS RECOMMENDED.
To start the pole pruner
1. Hold the pole pruner firmly
with both hands
2. Press and hold the safety switch
with your thumb.
3. Switch the pruner on with the
trigger switch. The safety switch
can now be released.
To stop the pole pruner
Release the trigger switch. The
chain and motor will quickly stop.