Ozito MACP-015 - OPERATION; Connecting to the Compressed Air Hose; Switching On and Off

CAUTION! TO REDUCE THE RISK OF ELECTRIC SHOCK,
WE RECOMMEND THE USE OF A RESIDUAL CURRENT
DEVICE (RATED AT 30MA OR LESS).
Connecting to the Compressed Air Hose
Disconnecting
3 Pull back the sleeve of the
quick-lock coupling whilst
pushing in the 1/4”nitto quick
plug. The quick-lock sleeve will
spring forward automatically,
connecting the accessory.
2 Attach the 1/4”male nitto quick
plug into the air tool you wish
to use.
1 Insert the 1/4 female nitto
coupler connector to the end
of the male connector on the
air hose.
3 Pull the safety release valve until
no air remains in the compressor
air tank.
1 To switch OFF the equipment, move
theOn/O󰀨switchtoposition“0”(O󰀨).
Disconnect the power cord from the
mains.
2 Disconnect tools from air hose.
3 To switch ON the equipment, set the
On/O󰀨switchtoposition“I”(On).
2 Connect the compressors power
cord to the mains power supply.
1 Attach the desired tool to the quick
release coupling of the air hose.
Switching On
Switching O󰀨
2. OPERATION
OPERATION
IMPORTANT!: WHEN RELEASING THE QUICK-RELEASE
COUPLING, BE SURE TO HOLD THE COUPLING PIECE
TO PROTECT YOURSELF AGAINST INJURY FROM THE
REBOUNDING HOSE.
IMPORTANT!: BEFORE CONNECTING OR DISCONNECTING
ACCESSORIES, ALWAYS MAKE SURE THAT THE
COMPRESSOR IS OFF.
WARNING!: COMPRESSED AIR CAN BE A
DANGEROUS FORM OF ENERGY. GREAT CARE IS
REQUIRED WHEN USING THE COMPRESSOR AND ITS
ACCESSORIES.
1 To disconnect the air tool, pull
back the sleeve on the quick-
lock coupling and remove the
tool.