Need help?Do you have a question about the Ozito MFT-012 and is the answer not in the manual?
General| Brand | Ozito |
|---|---|
| Model | MFT-012 |
| Category | Power Tool |
| Language | English |
Keep workspace clean and free from hazards to prevent accidents.
Ensure proper plug matching, avoid grounded surfaces, and protect from moisture.
Stay alert, use PPE, prevent unintentional starts, and maintain proper footing.
Maintain tools, use correctly, disconnect before adjustments, and store safely.
Service by qualified personnel using identical parts to maintain safety.
Charge for 7-9 hrs, repeat discharge/charge 4-5 times for optimal battery life.
Takes 3-5 hours; green light indicates a full charge.
Battery may warm; use at room temperature; avoid heat sources.
Battery stops if too hot; may need cooling before charging.
Align and insert battery until it clicks; do not force.
Depress release tabs and gently pull the battery out.
Charge fully, store cool, recharge if discharged, and periodically recharge.
Align accessory holes with spindle, secure with washer and locking bolt.
Loosen locking bolt, remove bolt and washer, then the accessory.
Align sanding paper to pad and press; peel off to remove.
Slide switch forward to 'on', backward to 'off' position.
Use speed dial to select oscillation frequency for desired application.
Select grit based on material and desired finish; higher grit is finer.
Use on wood, plastic, metal; keep tool flat on workpiece; do not apply heavy pressure.
Use on wood, plastics, sheet metal; clamp workpiece; use pendulum motion for plunge cuts on soft materials.
Remove fabrics, adhesives, vinyls; use correct angle and light pressure.
To Next Page
