Ozito OPCS-036 - Sharpening Guide; Fitting Chainsaw Guide; Fitting Blade Guide; Adjusting Attachments

2. SHARPENING GUIDE 3. ADJUSTING ATTACHMENTS
Fitting Chainsaw Sharpening Guide
2. Fit the blade sharpening
guide by rotating it
clockwise.
3. Fit the chainsaw sharpening guide by rotating it clockwise.
Before tting one of the sharpening attachments, you must
attach the desired accessory and secure by tightening the
collet nut.
4. Tighten the adjustable
height screw to secure in
the correct position.
1. Using the wrench,
loosen the adjustable
height screw on the
chainsaw sharpening
guide.
2. Place the wrench across
the top of the chainsaw
sharpening guide, aligning
the sharpening wheel with
the matching sized guide
on the wrench.
3. Adjust the height of
the guide so that the
sharpening wheel rests
against the guide on
the wrench.
Fitting Blade Sharpening Guide
Before using the chainsaw sharpening guide, the adjustable
height must be repositioned to correctly contact the sharpening
edge.
Chainsaw Sharpening Guide
1. Select the diamond
sharpening wheel that is
slightly smaller than the
gap in the chainsaw blade.
2. Remove shaft collar by
rotating anti-clockwise.
1. Remove shaft collar by rotating anti-clockwise.