2. PREPARATION
Adjusting the Cutting Height
The height adjustment lever provides 6 cutting heights from 30mm to 65mm.
1. Pull lever outwards away from
the mower body.
2. Adjust until the required cutting
height is selected.
3. Release lever and check that it is
securely seated in the required
cutting height position.
Note: The cutting height setting
has an inuence on the maximum
area that can be mown.
Mulching Adaptor
Side Ejector
In mulching mode the cuttings are shredded in the enclosed mower housing
and then spread back onto the lawn.
IMPORTANT! MULCHING IS ONLY POSSIBLE IF THE
LAWN IS RELATIVELY SHORT.
1. To use the mulching function,
remove the grass catcher, slide
the mulching plug through the
ejector opening and close the
grass catcher ap.
Note: The mulching adaptor must be tted in order to use the side ejector.
1. Lift up the side ejector ap with
one hand and guide the side
ejector adaptor with your other
hand onto the mower housing.
2. Lower the side ejector adaptor
and allow it to sit in place. Lower
the side ejector ap.
WARNING! ENSURE THE TOOL IS SWITCHED OFF
AND BATTERIES ARE DISCONNECTED BEFORE
PERFORMING ANY OF THE FOLLOWING TASKS.
1. Open the battery cover. Slide two
batteries of the same capacity
and same charge state into the
mower aligning the ribs so that
they click into place.
1. Open the battery cover. Press the
battery release tab and remove
the battery.
3. Insert the safety key.
(If the mower is not going to be
used immediately, do not insert
the safety key.)
2. Close the battery cover.
2. Close the battery cover.
Inserting the Batteries into the Mower
Removing the Batteries from the Mower
Only use 2 batteries with the same capacity. For best performance use 3.0Ah
batteries and above. Always use 2 batteries with the same charge state with
the mower.
With the four battery mounts it is an option to install 2 additional batteries,
this will increase the runtime of the mower. However, only use batteries with
the same capacity in pairs. For example, 2 x 4.0Ah on one side, and 2 x 3.0ah
on the opposite side. With four batteries installed, when the initial batteries
are exhausted, the second set of batteries will be activated.
Rear Ejector
To use the rear ejector function you must open the grass catcher ap slightly
and lock in place with the catcher ap locking lever.
1. Lift up the grass catcher ap,
swing up the locking lever and
insert its foot into the recess on
the mower housing.
Note: Do not use the mulching
adaptor when the rear ejector is
used.
To Next Page
Loading...
