EasyManua.ls Logo

Ozito PXSPSDMS-0182 - Troubleshooting; Spare Parts; Caring for the Environment; Description of Symbols

Ozito PXSPSDMS-0182
12 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Read instruction manual.
Nm
Newton Meters
Always keep the lawnmower on the ground when mowing.
Tilting or lifting the lawnmower may cause stones to be thrown out.
Beware of severing toes or hands. Do not put hands or feet near a
rotating blade.
Do not mow in the rain or leave the lawnmower outdoors while raining.
Keep bystanders away. Do not mow whilst people especially children
or pets are in the mowing area.
Blade continues to rotate after the machine is switched off. Wait
until all machine components have completely stopped before
touching them.
Pull out Safety Key before
carry out any repair work.
Regulator compliance mark
95
Sound power level
The equipment`s operating time depends on the battery with
the lower charge level. Therefore, only use rechargeable
batteries which are charged to the same level.
IPX1
Ingress protection from water
Wear eye and hearing protection.
CARING FOR THE ENVIRONMENT
Battery protection system
The tool is equipped with the battery protection system, which helps to ensure a long
service life.
The output power automatically cuts off during operation when the tool and/or battery are
placed under the following situations:
• When the tool is overloaded:
If this occurs, turn off and remove causes of overload, then turn on again to restart.
• When the remaining battery capacity becomes low:
Recharge the battery pack.
Note: The battery protection system does not in any way damage the tool.
Note: The indicated capacity may be lower than the actual level during use or
immediately after using the tool.
Power tools that are no longer usable should not be disposed of with household waste
but in an environmentally friendly way. Please recycle where facilities exist. Check
with your local council authority for recycling advice.
Recycling packaging reduces the need for landll and raw materials. Reuse of recycled
material decreases pollution in the environment. Please recycle packaging where
facilities exist. Check with your local council authority for recycling advice.
SPARE PARTS
Spare parts can be ordered from the Special Orders
Desk at your local Bunnings Warehouse.
Visit www.ozito.com.au or contact Ozito Customer
Service:
Australia 1800 069 486
New Zealand 0508 069 486
E-mail: enquiries@ozito.com.au
DESCRIPTION OF SYMBOLS
Problem Cause Remedy
Mower motor
is not starting
Possible clogging Check underneath the mower and clear out
as necessary
Battery is low in charge Charge battery
Battery not inserted
properly
Insert battery pack correctly
Grass too long Raise the cutting height to reduce starting
load
Safety key not inserted
correctly
Fit correctly
Thermal cut-out switch
has tripped
Let the equipment cool down for at least 10
minutes
The drive
motor does
not start
Mower standing in long
grass
Start motor on shorter grass or already
mowed area; change cutting height if
necessary
Mower housing is
clogged
Clean housing so that the blade can run freely
Mower is
hard to push
Height of cut too low Raise cutting height
Cutting blade blunt Replace blade
Possible clogging Check underneath the mower and clear out
as necessary
Grass too long Raise the cutting height and walk slower
Grass too dense Raise the cutting height and walk slower and
cut more frequently
Wet grass Wait until the grass dries before mowing
Motor stops
while cutting
Height of cut too low Raise the cutting height
Battery has no power Charge batteries
Mower is
not catching
grass properly
Height of cut too low Raise the cutting height
Wet grass Wait until the grass dries before mowing
Mower
vibrating
Bent or damaged blade Replace blade
Unclean cuts Blade worn Replace or sharpen blade
Wrong cutting height Adjust the cutting height
TROUBLESHOOTING

Related product manuals