ONLINE MANUAL
Scan this QR Code with your
mobile device to take you to
the online manual.
KNOW YOUR PRODUCT SETUP & PREPARATION
1. CHARGING
Note: On the initial charge, the battery requires 5 hours of
charging. Subsequent charging only requires 3-5 hours. It will take
4-5 charging cycles before the battery reaches optimum charge
and run time.
1 Magnetic Bit Holder
2 LED Worklight
3 Handle Lock Switch
4 Forward/ Reverse Lever
5 On/off Trigger
6 Sure Grip Handle
7 LED Torch
8 Torch On/off Switch
9 Charging Socket
CORDLESS SCREWDRIVER
This tool is recommended for the use with a residual current
device with a rated residual current of 30mA or less.
1. Plug battery charger into
power socket.
10 Charging Adaptor
11 Charging Jack
12 CRV Bits x 54
2. Insert the charging jack
into the charging socket.
3. A red light on top of the
screwdriver will illuminate
when properly connected
and charging.
To Next Page
Loading...
