J
Jacob KingAug 2, 2025
How to adjust the bevel angle on my Ozito UMS-1810 S?
- CCathy TaylorAug 2, 2025
To adjust the bevel angle on your Ozito Saw, first loosen the bevel angle lever, and then tilt the cutting head to the desired angle.
To Next PageTo Next PageHow to adjust the bevel angle on my Ozito UMS-1810 S?
To adjust the bevel angle on your Ozito Saw, first loosen the bevel angle lever, and then tilt the cutting head to the desired angle.
What to do if mitre table will not rotate on Ozito UMS-1810 S Saw?
If the mitre table on your Ozito Saw won't rotate, make sure you've loosened the mitre lock handle. Also, ensure that you press down the mitre adjustment lever.
What to do if my Ozito UMS-1810 S will not start?
If your Ozito Saw won't start, the issue might be due to a lack of power supply. Ensure that the saw is properly connected to a functioning mains outlet.
Why won't the cutting head on my Ozito Saw lower?
If the cutting head on your Ozito Saw won't lower, it's likely that the safety guard is preventing it. Pull back the safety guard stop to allow the guard to swing up, which should resolve the issue.
Why is there sparking visible through the vents of my Ozito Saw?
A small amount of sparking visible through the housing vents of your Ozito Saw is normal. However, excessive sparking could indicate worn carbon brushes, which may need replacement.
Steps to assemble the cutting head, material clamp, and support bars for the mitre saw.
Instructions for assembling the mitre saw stand, including attaching legs and supports.
Guidance on setting mitre angle and limiting cutting depth for precise cuts.
Step-by-step instructions for safely removing and installing saw blades, including safety precautions.
Precautions for safe use of electrical power tools and extension leads.
Covers work area, electrical safety, personal protective equipment, and tool usage precautions.
Specific safety guidelines for operating the mitre saw, including guards and workpiece handling.
Details the warranty period, conditions, and exclusions for the mitre saw.
General
