To Next Page
E
Elizabeth JohnsonAug 1, 2025
Why Ozito CMS-210 Saw won't start?
- TtprestonAug 2, 2025
If your Ozito Saw won't start, the issue might be due to a lack of power supply. Ensure that the saw is properly connected to a functioning mains outlet.
Why Ozito CMS-210 Saw won't start?
If your Ozito Saw won't start, the issue might be due to a lack of power supply. Ensure that the saw is properly connected to a functioning mains outlet.
What to do if my Ozito Saw starts but runs poorly?
If your Ozito Saw starts but its performance is poor, consider these potential causes: * The workpiece might be too thick. Ensure it's within the saw's cutting capacity. * The blade size could be incorrect. Make sure the correct blade size is fitted.
Why is sparking visible through the housing vents of my Ozito CMS-210 Saw?
A small amount of sparking visible through the housing vents of your Ozito Saw is normal. However, excessive sparking could indicate worn carbon brushes, which may need replacement.
Steps for removing the saw from packaging and preparing it for use.
Guidelines for moving the saw and securing it to a workbench or stand.
Procedure to release the cutting head from its locked transport position.
Instructions for setting the desired mitre and bevel angles for cuts.
Procedure for safely removing and installing a new saw blade.
Guidance on fitting dust bag, side support bars, and rear support bar.
Steps for starting and stopping the mitre saw.
Techniques for executing accurate straight and angled cuts.
Instructions for making cuts with the cutting head tilted at a bevel angle.
Guide to performing cuts combining mitre and bevel angles.
Procedures for power cable care and safe blade replacement.
Procedure to ensure the mitre table is square for accurate 0° cuts.
Procedure to align the rear fence for accurate square cuts.
Guidelines for cleaning the saw and checking carbon brushes and screws.
General| Blade Diameter | 210 mm |
|---|---|
| No Load Speed | 5000 RPM |
| Weight | 12.5 kg |
| Bevel Range | 0° - 45° |
| Mitre Range | 0° - 45° |
| Max Cutting Depth at 90° | 65 mm |
| Type | Compound Miter Saw |
