Ozito CMS-210 - Operation; Powering the Saw On and Off; Performing Straight and Mitre Cuts

11
Turning On and Off
1. To turn the Mitre Saw on, depress and hold the
on/off switch (8) (Fig. 14).
2. To turn the Mitre Saw off, release the on/off
switch (8).
CAUTION! Do not use the Mitre Saw to cut metal or masonry.
Straight and Mitre Cutting
A straight cut is made by cutting across the grain of the
workpiece. A 90° straight cut is made with the mitre
scale (27) set in the 0° position (Fig. 15).
Mitre cuts are made with the mitre scale (27) set at an
angle other than 0° (Fig. 16).
1. Ensure the cutting head (4) is raised. If the head
locking pin (5) is locked in place, pull the head
locking pin (5) (Fig. 17) and gently raise the cutting
head (4).
2. Loosen the mitre table lock knob (25) by turning in
an anti-clockwise direction (Fig. 18).
OPERATION
Fig. 14
Fig. 15
Fig. 17
Fig. 16
Fig. 18