paasche EZ-STARTER - User Manual

INSTRUCTIONS AND PARTS LIST EZ-STARTER AIRBRUSH 8/16/2019
EZ-STARTER
Single Action–External Mix–Siphon Feed
Instruction Manual & Replacment Parts
OPERATING INSTRUCTIONS:
Approximate Working Pressures:
• 20lbs.orLess:Stippleandgranulatede󰀨ects,pressurewillvarywithviscosityofuid.
• 20to30lbs.:Mediumconsistencywatercolors,inks&dyes.
• 30 lbs. or More:Heavyuids,acrylics,reducedlacquers,varnishes,paintsorceramicglaze.
1.Attachhosetoairsupplyand allowairto blowafew seconds.Shut o󰀨beforeattaching toAirbrush. Thisprocedurewill
removedirtfromairlineandhose.
Caution: Hold rmly and point away from face.
2. Attachhosecouplingtotheairbrush.
3.AttachColorCuporBottleto#6NeedlebyexertingarmtwistingmotiontottaperedtubesecurelyintotaperedNeedleinlet.
4. FillBottle1/2to3/4full.Useeyedropperorbrushforaddingsmallamountsofcolortometalcolorcup.Ventholemustbekept
open.
5.ToSpray,holdAirbrushlikeapencilcomfortablybetweenthumbandforengerusingmiddlengerasaguideandsupport.
Likewriting,holdforengereasilyonButtonandPresstoopenairvalve.
6.Regulatevolumeofcolorandsizeofspraybyrotating #5Tipclockwisetoincreaseandcounterclockwisetodecreaseow
ofcolor.
CARE AND CLEANING:
1.Pouranyremainingcolorbackintoitsoriginalcontainer.
2.WipeBottleclean,usingclothmoistenedwithpropersolvent.
3.HoldAirbrushatadownwardangleandputafewdropsofsolventthrough#6Needle,orllbottlewithPaintCleanertospray.
ToushouttheremainingcolorintheHColorAdjustingPartAssembly,applypressuretothe Button.
HOW TO OPEN CLOGGED FLUID PASSAGES:
1.AgitatecolorinBottleAssemblybyplacingngermomentarilyover#1AircapwhileairispassingthroughtheAirbrush.This
willblowcolorbackintobottlethusopeningcloggeduidpassages.
2.ShouldTiporNeedlebecomeclogged,pull#8Clip,unscrewTipfromNeedle,gentlypullbackthroughsupportandremove
Tip.
3.CleanPartscarefully,usingnothingharderthanawoodentoothpick&yourpaintcleaner.
4. Toreassemble,reversethisprocedure.
5.Iftheneedleandtiparecompletelyclogged,Remove#7“O”Ring(rst)thensoakinaclosedbottleofpropersolventuntil
clean.

Summary

Operating Instructions for EZ-Starter Airbrush

Approximate Working Pressures

Recommended air pressure ranges for different fluid viscosities and types.

Airbrush Setup and Connection

Steps for attaching the air hose and color cup/bottle to the airbrush.

Spraying Technique and Adjustment

Guidance on holding the airbrush and regulating color flow and spray size.

Care and Cleaning of the Airbrush

Routine Cleaning Procedure

Steps for flushing and cleaning the airbrush after use.

Troubleshooting Clogged Fluid Passages

Methods for Clearing Blockages

Techniques to resolve clogged tips, needles, and fluid passages.

EZ-Starter Airbrush Replacement Parts

Parts Identification and List

Diagram and list of numbered replacement parts for the airbrush.

Bottle Assembly Options

Illustrations and descriptions of various available bottle assemblies.

paasche EZ-STARTER Specifications

General

Brand	paasche
Model	EZ-STARTER
Category	Airbrushes
Language	English