PAB Fire Compact - Face Shield Replacement

www.pab.hr
FACE SHIELD REPLACEMENT
In case your face shield needs to be replaced, please follow the following
instructions:
1
Using a cross-tip screwdriver loosen the 2 screws on the inner sides of the shell
(see Picture 31).
2
Carefully disassemble all the parts: screw (1), inner plastic protector (2), gasket
(3), side covers (4), lamp holder adapters (5), and remove the old face shield from
its position.
3
Place the new face shield on the side holes and carefully reassemble all the
parts: screw (1), inner plastic protector (2), gasket (3), side covers (4) and lamp
holder adapters (5), to their original positions. Secure the visor and all the parts
with a crosstip screwdriver.
4
Before wearing the helmet, check if the face shield is properly xed – the face
shield should slide smoothly between standby and use positions.
For more information, please check regularly our website www.pab.hr or contact
directly PAB Akrapovic d.o.o.
PAB Fire Compact
Picture 31
1
2
3
4
5