PAB Fire Compact - Adjusting Face Shield and Goggles

www.pab.hr
PAB Fire Compact
1
*If you purchased a version with
integrated internal goggles, rst
position the internal goggles: pull
down the goggles into use position.
Pull them up into standby position
again when not needed.
To facilitate this step and to avoid
ngerprints on the goggles use the
tabs on the bottom left and right part
of the goggles.
ADJUSTING THE FACE SHIELD/VISOR AND INTEGRATED INTERNAL GOGGLES
(*Internal goggles are optional accessories)
2
Position the face shield: pull it down
into use position or pull it up (over
the helmet) into standby position.
To facilitate this step and to avoid
ngerprints on the visor use the bulge
at the bottom of the face shield.
Picture 20
Picture 21