PABX CS416 - 3.3.3 Trunk lines(c.o.lines) working assignment (UCD); 3.4 Setting Operating mode

Description: Disable all C.O. lines
Format: 061M#
Explanati o n: M: C.O. li n e No. M = 1 - 4
Description: Disable the M C.O. line
3.3.3
3.3.3
3.3.3
3.3.3 T
T
T
T runk
runk
runk
runk lines(c.
lines(c.
lines(c.
lines(c. o
o
o
o .lines)
.lines)
.lines)
.lines) w
w
w
w orking
orking
orking
orking assignment
assignment
assignment
assignment (UCD)
(UCD)
(UCD)
(UCD)
Format: 0 6 2 0 #
Description: This setting make the system assign the different trunk lines working av e rage l y, it
means the system will use the trunk lines circulating. (For example: the system will u s e trunk line
01, then line0 2, line03, …… line16 cir c ulating). This setting can avoid the user always use some
trunk lines.t h is is default setting.
Format: 0 6 2 1 #
Description: This setting make the s y stem use t r unk lines in sequence, it means the syst e m
always cho o se the trunk line of low e r numb e r if avail a ble. (line 01 is the lowe s t
numbe r )
3.4
3.4
3.4
3.4 Setting
Setting
Setting
Setting Operating
Operating
Operating
Operating mode
mode
mode
mode
3.4.1
3.4.1
3.4.1
3.4.1 Setting
Setting
Setting
Setting Auto-attendant
Auto-attendant
Auto-attendant
Auto-attendant Mode
Mode
Mode
Mode (OGM)
(OGM)
(OGM)
(OGM) for
for
for
for C.O.
C.O.
C.O.
C.O. Lines
Lines
Lines
Lines
Format: 1 0 #:
Description: allows all the C.O. lines in Auto-atte n dant Mode ( DISA --Dire c t Inward Sy s tem
Access s t at u s ). In this m o de, Caller w ill hear the OGM recorded message, while
all extensio n s are in MUTE mode
1. If the caller doesn ’ t know the ex t en s ion nu m be r , he cans inqu i ry the ope r ator by
dialing “ 0 ” .
2. Outgoing Message must be record when setting this mode.
Format: 1 0 M #
Explanati o n: M: C.O. line No.1- N o.4
Description: allows the No.M C.O. lines in Auto-att e ndant Mode( DISA --Direct Inward System
A cc ess s t atu s ).
P12