PAC C2R-CHYNA User Manual

Pacific Accessory Corporation
1502 S. Santa Fe St. Santa Ana, CA 92705
Voice: 714-835-3022 • Fax: 714-835-3233
www.pac-audio.com
10-12-06
DISCLAIMER: Under no circumstances shall the manufacturer or the distributors of the C2R-CHYNA parts be held liable for consequential
damages sustained in connection with the C2R-CHYNA. The manufacturer and it’s distributors will not, nor will they authorize any
representative or any other individual to assume obligation or liability in relation to the C2R-CHYNA other than its replacement.
Installation:
1. Only for Vehicles Without a Factory Amplifier: Connect the aftermarket radio’s front and rear speaker wires to the 22 pin plug.
2. The 22 pin harness has two yellow and two black wires. Connect both yellows to the radio’s +12v constant wire and both blacks
to the radio’s ground wire.
3. The Accessory wire is located on the 6 pin harness - connect this wire to the radio’s accessory wire. The accessory wire supplies
+12v, 1 amp max, when key is in the Accessory or Ignition position.
4. 11 pin plug: Orange/White - Connect this wire to the radio’s Illumination input wire only.
Note: Do not connect these wires to any other circuit besides the radio’s wire harness.
5. When all connections are made, connect the 22 pin plug into the vehicle’s 22 pin harness.
9
78
011
1
1 amp
fuse holder
1#
2#
tuptuO yr
o
ssec
c
A
.xam p
m
a1
s
t
l
ov
2
1
+
22 pin
Chrysler R
6 pin
Orange/White = Illumination
Yellow x 2 = +12v Constant
Black x 2 = ground
Gray = Right Front (+)
Gray/Black = Right Front (-)
White = Left Front (+)
White/Black = Left Front (-)
Violet = Right Rear (+)
Violet/Black = Right Rear (-)
Green = Left Rear (+)
Green/Black = Left Rear (-)
Red = +12v
Accessory output
To optional SWI-CAN interface for retaining steering wheel audio controls
1
1 pin
C2R-CHYNA
C2R-CHYNA
Radio Replacement interface for 2004+
Chrysler, Dodge and Jeep vehicles
with Factory Radio Models REF, REC, RAQ and RAK.
1
23456
For Use with Aftermarket Radios to Retain Accessory Power
• Retains Accessory Power for Approximately 10 Minutes or Until A Door is Open

PAC C2R-CHYNA Specifications

General

Product Type	Radio Replacement Interface
Steering Wheel Control Retention	Yes
Amplifier Turn-On	Yes
Voltage	12V
Compatibility	Select Chrysler, Dodge, Jeep, and RAM vehicles
Function	Retains factory features when replacing the radio
Navigation Outputs	Yes
Interface Type	CAN Bus

Summary

Retain Accessory Power Functionality

Installation Guide

Vehicle Amplifier and Speaker Wiring

Connect aftermarket radio speaker wires to the 22 pin plug for vehicles without a factory amplifier.

22-Pin Harness Connections

Connect 22-pin harness yellow wires to +12v constant and black wires to ground.

6-Pin Harness Accessory Wire

Connect the accessory wire from the 6-pin harness to the radio's accessory wire.

11-Pin Plug Illumination Wire

Connect the 11-pin plug's Orange/White wire to the radio's illumination input only.

Final 22-Pin Harness Connection

Connect the 22-pin plug into the vehicle's 22-pin harness once all connections are made.