Maintenance Procedures
5
WARNING!
Electrical shock hazard: Never dis-
connect the battery clamp when the
engine is running. Disconnecting
the battery clamps while the engine
is running may result in death, per
-
sonal injury or equipment damage
from electrical arcing or damage to
electrical components.
WARNING!
Turn off the engine and place the
ignition switch in the OFF position
before disconnecting the battery
clamps. Do not place any tools or
other materials on top of or close to
the batteries. This can cause a dan
-
gerous high current short circuit and,
in the worst case, a battery explo
-
sion. Keep all objects away from the
battery terminals. Always break the
contact between the battery clamp
and the negative terminal before
working on the vehicle. Working
on a vehicle while the battery is
connected may result in electrical
injury or damage. Always discon
-
nect the battery at the negative
terminal when performing service
procedures. Failure to comply may
result in death, personal injury or
equipment damage.
Centrifugal Bypass Oil Filter
Removal
1. Remove the cap of the centrifugal
oil lter. Use a hexagonal socket
to avoid damaging the oil lter cap.
2. Remove the centrifugal lter.
3. Remove the O-ring from the screw
cap.
2. Place an oil collection pan directly
under the oil lter.
5-26
To Next Page
Loading...
