16
RNG110 OPERATOR’S MANUAL (501-3438000)
Restoring the factory default settings
If you wish, you can restore the user settings to their factory defaults. All the changes you have made will be
lost and the settings will revert to those that were programmed in the factory.
The factory settings are:
USER/SUBTITLE SETTINGS menu item Options Factory default setting
TV Aspect Ratio – 16:9
TV Display Capability 1080i
720p
480p
480i
1080p24 Pass
1080p30 Pass
Yes
No
Yes
Yes
No
No
Auto Pillarbox – No
Closed Captions – Off
Configure Captions Various All Auto except Hi Def CC, which is
Service 1
Front Panel Settings Standby Brightness
Viewing Brightness
Std
High
HDMI Settings Audio Output Mode
Disable Auto Detect
Auto
No
Subtitles – Off
Subtitle Language – English
If you have not done so already, put your set-top into User Settings mode, as described on page 11.
1. Press the U or D button on your remote control and highlight Restore Defaults on the PACE USER
SETTINGS menu.
2. Press the R button. The message: “Restore Default. Press OK to confirm” appears on your TV screen.
(If, at this stage, you no longer wish to restore the factory settings, press the L button.)
3. To confirm and restore the factory settings, press the OK/Select button.
The factory settings are restored, and the PACE USER SETTINGS menu reappears.
4. If you want to continue changing the settings, see the sections from page 11 onwards. If you have finished
changing the settings, press the POWER button. Your set-top then switches on with the restored settings.
NOTES
If your set-top and HDTV are connected via a standard HDMI cable, your HDTV may pass information
about the required settings back to your set-top (see page 12). If you wish to restore your set-top’s
settings to those created by your HDTV, you must disconnect the HDMI cable from your set-top before
you restore the factory default settings. When you reconnect your HDTV to your set-top via the HDMI
cable, your HDTV will pass back the information again.
Always turn off your set-top, then disconnect your set-top’s power supply unit from the wall AC outlet
before you connect or disconnect any other equipment to or from your set-top’s rear panel.
MAKING USER SETTINGS (cont.)
To Next Page
Loading...
