7
Full features cradle interface
Full features cradle cable pin assignment overview
The cradle cabling can offer the below functionalities in the full feature cradle:
- Vehicle Input: DC 12V to 32V, ignition control with optional switch in the cradle
- Serial port: RS485 x 1, RS232 x 2
- Support one channel video input (Support AHD 720P, 1080P and Analog camera)
- Support four channels video input, connect to Camera Hub by extension cable (Refer to
the Camera Hub manual), with 4 trigger input
- GPIO: Analog input ADC x 1, Digital input x 2, Digital output x 1
Vehicle Input: DC12V to 32V, ignition control with optional switch in the cradle
①
Fasting-charging AC adapter or charge input 5V/3A, 9V/2A, 12V/2A with Type-C USB
connector.
②
USB 2.0 OTG Connector x 2
③
RJ45 connector used for Ethernet
④
Ignition switch: the ignition switch is switched to the right side, charging is independent
of ignition ON/OFF. If ignition switch is switched to the left side, charging is dependent of
ignition ON.
To Next Page
Loading...