Pacific hydrostar 69747

Questions and Answers

C
Catherine HancockAug 1, 2025
What to do if my Pacific hydrostar Water Pump does not pump water?
- R
  Rhonda PerkinsAug 1, 2025
  If your Pacific hydrostar Water Pump isn't pumping water, it could be due to several reasons. First, ensure the pump is properly primed. If that's not the issue, check for clogs in the intake strainer and clean or replace it if necessary. Also, inspect for air leaks at the intake connector, replacing the coupling gasket or tightening the clamp if needed. Other potential causes include hose leaks (replace the hose), a collapsing suction hose (use a non-collapsible hose), a suction hose with too small a diameter (use a 3" or greater diameter hose), or the pump being too high above the water surface (locate the pump at a lower level).
C
conniemillerAug 8, 2025
Why is the output of my Pacific hydrostar 69747 so low?
- T
  Terry BrownAug 8, 2025
  If you're experiencing low output from your Pacific hydrostar Water Pump, several factors could be responsible. Start by checking the suction hose for any damage, collapse, excessive length, or insufficient diameter; replace or adjust it as necessary. Next, inspect the connector for air leaks, and replace the coupling gasket or tighten the clamp if needed. Also, make sure the strainer is clean. Finally, examine the discharge hose for any damage, excessive length, or insufficient diameter; replace or adjust it accordingly.
C
Cynthia ScottAug 15, 2025
What to do if my Pacific hydrostar 69747 unit stalls?
- D
  Denise WoodAug 15, 2025
  If your Pacific hydrostar Water Pump unit stalls, it might be due to several reasons. A qualified technician should increase the no-load speed to 3,800±100 RPM by adjusting the pressure switch. Also, check the air filter, because a severely clogged air filter can cause stalling, so replace it. Improper lubrication can also cause stalling, so check for proper oil level.
K
Kimberly HendricksAug 23, 2025
Why does my Pacific hydrostar Water Pump overheat?
- P
  ppalmerAug 23, 2025
  If your Pacific hydrostar Water Pump overheats, it could be due to incorrect or insufficient lubrication. Make sure to lubricate the pump using the recommended oil or grease, following the provided directions. Another possible reason is worn parts, in which case you should have a qualified technician inspect the internal mechanism and replace any parts as needed.