Pacific Power Source LMX Series - Table 6-23: Available RAMP TIME & SLEW RATE SETTINGS Screen Soft Keys

LMX SERIES™ OPERATION MANUAL
SECTION 6:
Front Panel Operation
Entire Contents Copyright  2018 by Pacific Power Source, Inc. (PPS) • All Rights Reserved • No reproduction without written authorization from PPS.
LMX Series Power Source Operation Manual Page 143 of 463
The soft keys on the SLEW RATE SETTINGS screen provide access to additional functionality
as listed in the table below.
SOFT KEY
Description
Apply All (SK1)
Applies all changes made (highlighted in grey) and returns to
previous screen.
Cancel All (SK2) Cancels all changes (highlighted in grey), sets slew rates back to
prior settings and returns to previous screen.
Enable Ramp T. Enables Ramp time, disables Slew rate settings
Enable Slew R.
Enable Slew Rate settings, disables Ramp time
Back (SK5) Returns to the previous screen.
Table 6-23: Available RAMP TIME & SLEW RATE SETTINGS screen soft keys