Need help?Do you have a question about the Packo HP64 and is the answer not in the manual?
Explains how the HP & LH pumps operate, detailing rotor movement and fluid transfer mechanism.
Highlights crucial safety instructions and precautions for operating and servicing the pump, including warnings.
Outlines critical operating parameters like priming, pressure, solids, and cavitation to prevent damage.
Covers drive selection, requirements, and coupling methods for the pump, including direct coupling and motor reducers.
Details requirements for machine guarding and safety, stating machinery must be complete before use.
Provides instructions for safe and correct electrical connection of the pump motor by qualified personnel.
Describes the types of mechanical shaft seals and flushing systems available for the pumps and their applications.
Lists various protection devices like pressure switches and torque limiters to prevent system damage from excessive pressures.
Details the pre-start checks and procedures for the initial pump operation, including safety and fluid checks.
Explains procedures for cleaning pumps using CIP methods and manual cleaning techniques for fluid contact surfaces.
Details the process for sterilizing the pump and system using steam, emphasizing temperature and hold times.
Explains how to check and adjust rotor clearances using shims for optimal pump performance.
Explains how to remove and replace gearbox shafts, gears, and bearings, including pre-assembly checks.
Details the procedure for setting up and pre-loading bearings for shafts to prevent end-float.
Details the maximum permitted surface temperatures of pump components based on media temperature and ATEX class.
General| Brand | Packo |
|---|---|
| Model | HP64 |
| Category | Water Pump |
| Language | English |
To Next Page
