20
21
NOTE!
Inform your child about the dangers and use of the GPS tracker.
Please make sure that your child does not handle small parts (e.g. accesso-
ries, etc.). These can be swallowed and lead to suffocation.
Below you will nd information and instructions on how to use the battery:
• The GPS tracker runs by a lithium ions battery. It is not exchangeable and
must not be removed or opened.
• Make sure that the GPS tracker (also when charging the battery) is kept away
from heat sources and high temperatures, such as direct sunlight in a vehicle.
Disregard of this instruction may result in destruction of the battery and
overheating, explosion and re.
• Only use the original accessories for the charging process. If the battery is
charged otherwise, this may result in overheating, explosion or re.
• Do not burn or pierce the GPS tracker. Protect it from mechanical damage.
• If a child swallows the battery, seek medical aid immediately!
Removing or replacing the battery:
• Contact our support if the battery needs to be removed or replaced.
• Send the machine to us to remove or replace the battery.
WARNING! EXPLOSION AND FIRE HAZARD!
The battery
• For safety reasons, do not attempt to remove the battery. Failure to remove
the battery properly may result in damage to the battery and unit, personal
injury and/or compromise the safety of the unit.
• PAJ GPS shall not be liable for any damage or loss (whether in contract or tort,
including negligence) arising from your failure to comply with these warnings
and instructions.
Batteries that leak due to damage can cause burns if they come into contact with
the skin. Therefore, never open the battery. However, if the battery leaks, please
wear protective gloves.
WARNING! RISK OF CHEMICAL BURNS!
NOTE!
Failure to observe these recommendations may result in malfunctions or
damage to the GPS tracker.
Electromagnetic compatibility
Please observe all rules and prohibitions and switch off the GPS tracker immedia-
tely in danger areas and if it might cause interference. Furthermore, it should not
be used in the vicinity of, for example, medical equipment, fuels and chemicals, or
in blasting areas. With mobile devices, malfunction due to interference may occur
and affect performance. Transformers and very strong magnetic elds must be
avoided. Otherwise there may be deviations in the transmission.