10
11
1.7 Use
A s s o o n a s y o u r d e v i c e h a s b e e n s u c c e s s f u l l y a c t i v a t e d , s t a r t e d u p a n d h a s s e n t
a n d l o g g e d d a t a f o r t h e f i r s t t i m e , y o u c a n p la c e i t w h e r e v e r y o u c h o o s e an d u s e
y o u r p h o n e , t a b l e t o r P C t o s t a r t t r a c k i n g i t ! Y o u w i l l b e a b l e t o d o t h i s i n o u r A p p o r
enter the following link to the desktop version:
v2.nder-portal.com
1.8 Standby mode and location update
By default, our devices send their position to the FINDER portal every 30 seconds, so
you can always see the current location there.
What is the standby mode?
As soon as the FINDER is no longer moved, standby mode is activated after a few
minutes to save power. This suspends the update of the location for the duration
of the standstill of the unit. In the FINDER portal, the standby mode is displayed
as follows:
Nevertheless, the unit naturally remains on standby and still sends alarm mes-
sages. As long as the FINDER is in standby mode, only the data (time, battery
status, etc.) of the last position before standby mode is displayed on the portal,
as the position does not change during standby.
Online mode
At the latest, when the FINDER is moved again, the device automatically switches
to active and sends its position to the portal again every 30 seconds.
Location update in standby mode
If the FINDER is in standby mode for a longer period of time, the unit will still send
a new position to the portal at least every 24 - 26 hours.
To Next Page
Loading...
Need help?
General