Tungsten™ E2 Handheld 16
CHAPTER 1 Setting Up Your Handheld and Your Computer
MAC ONLY
0
1 Begin synchronization:
a. Connect the USB sync cable to the USB port on the back of your computer,
and then insert the other end into the Multi-connector on your handheld.
b. Press the sync button on the USB sync cable.
2 Select the profile you want to
load on the handheld, and
click OK.
The next time you synchronize that handheld, Palm Desktop
software prompts you to assign a username to the handheld.
Done
To Next Page
Loading...
