Paloform CIR-E-18 - OPERATING INSTRUCTIONS; WARNING: This appliance is designed to be connected to a power source that is controllable by a switch.; Do not connect AC adapter to a live power source.; TURNING OFF THE GAS TO THE APPLIANCE

11
BENTO 42 E | Owner and Installation Manual
LIGHTING YOUR FIRE PIT
OPERATING INSTRUCTIONS
1. STOP! Read the safety information on pages 1, 2 and 8 of this
manual.
2. Turn o all electric power to the appliance.
3. Do not attempt to light the pilot manually.
4. Turn the supply gas control valve to the OFF position.
5. Wait ve (5) minutes to clear out any residual gas, then check for the
smell of gas at and around the appliance, including near the oor. If
you smell gas, STOP! Follow the instructions on page 1 of this
manual. If you do not smell gas, continue to the next step.
6. Turn the supply gas control valve to the ON position.
7. Plug the supplied AC adapter into a 110V power outlet.
8. Connect the AC adapter to the AC input plug at the unit.
9. Place Burner Assembly in Housing
10. To ignite buner, turn on electric power to the appliance.
11. To turn o appliance, turn o electric power to the appliance.
TURNING OFF THE GAS TO THE APPLIANCE
1. Turn o all electric power supplied to the appliance if service is to
be performed.
2. If necessary, remove the burner from the housing to access the
manual gas valve.
3. Turn the main manual shuto valve to the full OFF position. Unplug
the AC adapter from the power outlet.
WARNING:
This appliance is designed to be connected to a power
source that is controllable by a switch.
Do not connect AC adapter to a live power source.