Paloform CIR-E-18 - PLACEMENT AND ASSEMBLY; CAUTION: HEAVY: Use care when lifting and placing to avoid injury and damage to property and the fire pit itself. Fire pits will require 2 or more people to lift.; ATTENTION: Fragile! Concrete may chip or scratch if collided with other hard materials such as stone, metal, or other concrete. HANDLE WITH CARE!

4
BENTO 42 E | Owner and Installation Manual
CAUTION:
HEAVY: Use care
when lifting and
placing to avoid
injury and damage
to property and the
re pit itself. Fire pits
will require 2 or more
people to lift.
PLACEMENT AND ASSEMBLY
1. Please refer to ‘Clearances to Combustibles’ guide on page 6 of this guide for placement.
2. Ensure that the nal location for the re pit is as at and level as possible. Also provide adequate drainage
beneath the opening in the base of the re pit body.
3. Completely unpack the re pit.
4. Remove Burner Assembly (1) from re pit body and carefully set aside.
5. Carefully lift the re pit and place it in its nal position. If there is a gas riser, re pit vessel should be placed
so that the stub is enclosed within the re pit body (3).
6. If the re pit does not sit level, shim appropriately so that it is level and evenly supported.
7. Connect to Natural Gas or Propane Source as per page 8 of this manual.
8. Assemble Burner as per instructions on page 7.
9. Check for leaks and test burner (see page 8).
10. Place Burner Assembly in Body.
11. Cover with Decorative Topping media as per instructions on page 7.
ATTENTION: Fragile! Concrete may chip or scratch if collided with other hard
materials such as stone, metal, or other concrete. HANDLE WITH CARE!