5
UNPACKING
Carefully remove the Commander HF2500 EXPORT Amplifier from its shipping carton
making sure there is no damage evident from shipping. If there is any damage, notify the deliv-
ering shipper immediately, fully describing the damage.
The HV power transformer was shipped separately, as its weight would damage the cabinet
in transit.
Do not destroy the packing material since it may be reusable later, should you require fac-
tory service or need to transport the Amplifier for any other reason.
TRANSFORMER INSTALLATION
Remove the top cover from the amplifier chassis. Install the transformer following the illus-
trated procedure beginning on next page.
SHIPPING BLOCK
The 3CPX800A7 tubes are shipped installed in the amplifier, held in place by a Styro-
foam block. Remove the block before use.
200/234 VAC Operation
The Commander HF2500 EXPORT comes factory wired for 234 VAC operation. For best
operation, you should use a dedicated 234VAC main capable of supplying 30 Amps of peak AC
current.
Commander Amplifiers manufactured for export are wired for 234 VAC or 200 VAC de-
pending on the final destination.
To Next Page
Loading...
