79
Menu Displays
Setup menu list
[SCENE FILE] screen
Item
Display
mode
Description of settings
[LOAD/SAVE/
INIT]
<CAMERA>
[LOAD]: Loads the scene le settings saved in this camera.
[SAVE]: Saves the updated scene le settings.
[INIT]: Returns the scene le settings selected using the <SCENE FILE>
dial, to the factory settings.
[NO]: Returns to the previous screen.
[SYNC SCAN
TYPE]
<CAMERA>
Selects the synchro scan display setting.
[deg.]: Sets to angle display.
[sec]: Sets to speed display.
[SYNCHRO
SCAN]
<CAMERA>
Adjusts the synchro scan shutter speed used for shooting images on a TV
screen, etc.
Holding the OPERATION lever tilted upward or downward will cause the values
to change at a faster rate.
•
When [SYNC SCAN TYPE] = [sec]
60i/60 P mode: [1/60.0] - [1/249.8] secs
30 P mode: [1/30.0] - [1/48.0] - [1/249.8] secs
24 P mode: [1/24.0] - [1/48.0] - [1/249.8] secs
•
When [SYNC SCAN TYPE] = [deg.]
[3.0 d] - [180.0 d] - [360.0 d] (0.5 d increments, angle display)
[DETAIL
LEVEL]
<CAMERA>
Adjusts the level of the image outline correction (in the horizontal and vertical
directions).
[-7]
…
[0]
…
[+7]
[V DETAIL
LEVEL]
<CAMERA>
Adjusts the level of outline correction in the vertical direction.
[-7]
…
[0]
…
[+7]
[DETAIL
CORING]
<CAMERA>
Adjusts the level of noise reduction of the detail signal.
Set to – for a clearer image, but noise increases slightly.
Set to + to reduce noise.
[-7]
…
[0]
…
[+7]
is the factory default mode for the <SCENE FILE> dial <F1>.
Menu
To Next Page
Loading...
