Panasonic AG-AC160A - Page 98

98
Item
Display
mode
Description of settings
[DV CMD SEL] <CAMERA>
(DV mode
only)
Sets the recording operation to be performed by the backup device when you
press the <START/STOP> button.
[REC P]: Pauses and unpauses the recording.
[STOP]: Starts and stops the recording.
[TALLY LAMP] <CAMERA> Sets lighting of the tally lamp.
[FRONT]: The front tally lamp (microphone side) lights.
[REAR]: The rear tally lamp (viewnder side) lights.
[BOTH]: Both tally lamps light.
[OFF]: No tally lamp lights.
[CLOCK SET] <CAMERA>
<PB>
Sets the built-in calendar of the camera.
[TIME ZONE] <CAMERA>
<PB>
Adds to or deducts from GMT the time value of [-12:00] to [+13:00] in 30-minute
steps. (Refer to the following table.)
[0:00]
Time
difference
Region
Time
difference
Region
+00:00 Greenwich –00:30
–01:00 Azores –01:30
–02:00 Mid-Atlantic –02:30
–03:00 Buenos Aires –03:30 Newfoundland Island
–04:00 Halifax –04:30
–05:00 New York –05:30
–06:00 Chicago –06:30
–07:00 Denver –07:30
–08:00 Los Angeles –08:30
–09:00 Alaska –09:30 Marquesas Islands
–10:00 Hawaii –10:30
–11:00 Midway Islands –11:30
–12:00 Kwajalein Atoll +12:30
+13:00 +11:30 Norfolk Island
+12:00 New Zealand +10:30 Lord Howe Island
+11:00 Solomon Islands +09:30 Darwin Islands
+10:00 Guam +08:30
+09:00 Tokyo +07:30
+08:00 Beijing +06:30 Yangong
+07:00 Bangkok +05:30 Mumbai
+06:00 Dacca +04:30 Kabul
+05:00 Islamabad +03:30 Tehran
+04:00 Abu Dhabi +02:30
+03:00 Moscow +01:30
+02:00 Eastern Europe +00:30
+01:00 Central Europe
[LANGUAGE] <CAMERA>
<PB>
Sets the Menu language.
[English], [Español], [Français] (AG-AC160AP)
[English], [Español], [Français], [Deutsch], [Italiano] (AG-AC160AEJ)
[English], [Español], [Русский] (AG-AC160AEN)
[SYSTEM
FREQ]
<CAMERA> Sets the system frequency. (The factory setting values may vary depending on
the region.)
[59.94Hz]: NTSC region
[50Hz]: PAL region
•
If the [TURN POWER OFF] message is displayed, switch the camera OFF and
then ON again. Every time the power is turned on, the system frequency changes.
[SYSTEM
INFO]
<CAMERA>
<PB>
Displays the version of the system in this camera.
is the factory default mode.