1-5
1.6 HOW TO REMOVE THE MECHANISM ASSEMBLY
To remove only the mechanism assembly from the mechanism
unit.
(1) Remove the shield case on the DV/CPU board and remove
the CN107 FPC wire from the drum assembly.
Fig. 1.6.1
(2) Remove the FFC wires that connects the mechanism board,
which is mounted on the backs of the mechanism assem-
bly, MDA/DC board, and the DV/CPU board.
(3) Remove the four screws
7
on the side.
(4) Remove the mechanism assembly as shown in Fig. 1.6.3.
Fig. 1.6.3 Mechanism assembly
For instructions on disassembling each part of the mecha-
nism assembly, please refer to the Section 2.
Fig. 1.6.2
CN107
7
7
To: CN119
MDA/DC board
To: CN117
MDA/DC board
To: CN114
MDA/DC board
To Next Page
Loading...
