1-6
Gear
Ç
Fig. 1.7.4
1.7 HOW TO TAKE OUT THE CASSETTE TAPE IN CASE
OF EMERGENCY
An emergency system on this unit enables the cassette tape to
be taken out manually.
When a cassette tape is stuck, take it out as described below.
Procedure
1. Gear
Å
: Emergency gear for MODE MOTOR
2. Gear
ı
: Emergency gear for REEL MOTOR
3. Gear
Ç
: Emergency gear for HOUSING MOTOR
(1) In order to turn the mode motor, turn the gear
Å
(red color)
in the direction of the arrow. While turning the gear also
push it in to drive loading / unloading.
Fig. 1.7.1
(2) To wind the tape, when the tape is loosened a little, put a
screw driver in the emergency gear
ı
, which drives the
reel. (The drive direction does not matter.)
Fig. 1.7.2
Gear
Å
Gear ı
Fig. 1.7.3
(3) Repeat steps (1) and (2) alternately and little by little until the
tape is wound completely into the cassette.
(4) Confirm that the tape is completely wound. Then, turn the
gear
Ç
(red color) in the direction of the arrow to eject the
cassette housing. Take the cassette out when it comes out
of the loading slot.
To Next Page
Loading...
