Panasonic AG-HMC80PJ - Tv;Monitor

52
Chapter 1: Operations in AVCHD mode
Connecting external units (continued)
TV/Monitor
Only the output signals from the camera are shown.
VIDEO
COMPONENT
OUTPUT
CAMREMOTE
ZOOM
S/S
FOCUS
IRIS
Y/
VIDEO
P
B
P
R
ON
LINE MIC LINE MIC
OFF OFF
AUDIO
IN
AUDIO
OUT
MIC+48V
ON
MIC+48V
CH 1 CH 2 CH 2
CH 1
HDMI cable (optional)
Audio cable (optional)
Video cable
(optional)
Connect
these
cables
to the
terminals
on the
television.
TV/Monitor
When outputting video and audio signals from the camera to an external device, connect to the
input terminals of the external device.
It is recommended that you use Panasonic’s HDMI cable.
HDMI output will take priority if both HDMI cable and VIDEO OUT cable are connected at the same time.
Simultaneous output is not possible.
This product is not compatible with VIERA Link.
Since the component terminal only outputs pictures, an audio cable must be connected at the same time.
(Connect the cable to the audio input terminal of the component terminal input. For details, refer to the
operation manual for the TV.)
The component terminal of the unit is the BNC type. To connect a pin-type cable, use a pin-BNC
converter plug (optional).
•
•
•
•
•
Output by HDMI output, COMPONENT OUT, and VIDEO OUT
When an HDMI cable is connected simultaneously with a COMPONENT cable or a VIDEO cable, HDMI
output is prioritized.
Simultaneous output from COMPONENT OUT and VIDEO OUT is not possible. Output is determined by
the terminal selected by the OUTPUT switch.
■
■
•
•