23
This menu is selected using the A or B bus [Color Effects] button. If the status of the [Color Effects] button is not to be
changed, press the [Color Effects] button of the bus to be set while holding down the [Shift] key.
Settings can be performed separately for the A bus and B bus.
Preview is set to A by pressing the [Color Effects] button for A.
Preview is set to B by pressing the [Color Effects] button for B.
The Y setup [0 to 255] can be set using the rotary 1 control. The default setting is 128.
The Y gain [0 to 255] can be set using the rotary 2 control (0dB=0). The default setting is 128.
The Pb and Pr color balance can be set using the joystick’s X direction (for adjusting Pb) and rotary 3 control or using the
joystick’s Y direction (for adjusting Pr) and rotary 4 control, and the chroma gain can be set using the rotary Z and rotary 5
controls.
At this time, the XYZ display is switched to Pb/Pr/C Gain.
Using transition pattern numbers 200 to 211, 215 to 220 and 222, effects are applied to the B or Preset bus using the settings
established for this channel, and the pattern is changed to MIX (56).
<Notes>
≥ In the case of pattern numbers 221, 222, 1068 and 1069, color effects can be applied to the B channel and transitions can
be initiated. When this is done, the pattern is changed to MIX (56). (With the A bus/B bus)
With the preset bus/program bus, the effects are applied to preset, and they are turned off by setting the reverse button to
ON.
≥ Color effects cannot be applied to the INT EXT inputs.
[Color Effects] setting screen
Color Pb 128 Pr 128
Effect C Gain 128
Event ME Time Pattern INT
00E 10:00F 3015 Blue
Color Effects
ch A
Y Setup
128
Y Gain
128
Pb
128
Pr
128
C Gain
128
R1 R2 R3 R4 R5
To Next Page
Loading...
