Panasonic AG-UX170 - Operations During AG ROP Application Connection

- 154 -
Operations during AG ROP application connection
∫ Operations with this unit during connection
≥ The following buttons are disabled:
j SHUTTER button
j GAIN button
j WHITE BAL button
j MENU button (The applicable USER button is also disabled, making it impossible to operate
the menu.)
j BARS button
j THUMBNAIL button
≥ You can change the [ZOOM/FOCUS] setting in the [SW SETUP] menu to switch between
operating this unit and operating it with the AG ROP application. Since selecting [IP REMOTE]
will disable the following switches and buttons, to operate them with this unit, select [CAMERA]:
j Focus ring
j Zoom lever
j Sub zoom lever
j PUSH AUTO button, USER button to which [PUSH AUTO] is registered.
j FOCUS A/M/¶ switch
j Switching to Auto Focus Mode with the AUTO/MANU switch (l 45)
≥ You can press the IRIS button to switch between operating the iris ring of this unit and operating it
with the AG ROP application. The iris ring of this unit cannot be used when you operate this unit
with the AG ROP application.
∫ Recording and playback operations during connection
You can perform operations with either this unit or the AG ROP application while connected to the
AG ROP application.
∫ Limitations on this unit during connection
≥ The following functions are disabled during AG ROP application connection:
j Magnifying the Focus Assist display (l 57)
j Focus Transition (l 62)
j USB Mode (USER button) (l 87)
j Area Mode (l 92)
≥ Settings that are changed remotely with the AG ROP application are applied to the corresponding
settings of this unit.
≥ When is flashing on the AG ROP application screen, remote control operations may
not be performed due to an error on this unit. Check this unit. For details, refer to “Warning
Indications” on page 216.
WARNING
AG-UX180ED(DVQP1171ZA)_E.book 154 ページ ２０１６年１１月２８日 月曜日 午前１１時３２分