Panasonic AG-UX90 - Page 24

24
SW SETUP <continued>
Menu item
Description
Value (Factory default setting underlined)
PEAKING
COLOR
Set highlighting color for
the peaking focus assist.
Red / Blue / Yellow / White
PEAKING LEVEL
Set highlighting level of the
peaking focus assist.
-7 – 0 – +7
FOCUS RING
DRIVE
Set the type of focus
control by the focus ring.
SPEED(*) / COARSE / FINE
* Focus control speed varies in response to
rotation speed of the focus ring.
FOCUS MACRO
Turn ON/OFF macro
mode.
ON / OFF
Focus adjustable range at wide-end is from
10cm to infinity with MACRO: ON. (from
1meter to infinity with MACRO: OFF).
AREA MODE
Choose the feature that
works when tapping the
subject on the built-in
LCD.
INH, FOCUS, IRIS, YGET, FOCUS/IRIS,
FOCUS/YGET
INH：No function is assigned.
FOCUS：Adjust the focus so that the pointed
subject is in focus.
IRIS：Adjust the iris so that aperture level is
appropriate for the pointed subject.
Y GET：Indicate Y level of the pointed subject.
FOCUS/IRIS：Adjust both focus and iris for the
pointed subject.
FOCUS/YGET：Adjust focus and indicate Y level of
the pointed subject.
CUSTOM AF
AF characteristic
customization (AF Speed
and sensitivity) can be
used when this item is set
to ON.
ON / OFF
AF SPEED
Set speed of auto focus
control.
-5 - 0 - +5
AF SENSITIVITY
Set sensitivity of auto
focus control.
0 – 5 - 10
AF AREA WIDTH
Set the size of window
where auto focus is
enabled.
Use the jog-dial to adjust window size.
WFM
(AG-UX180 only)
Display the Waveform or
Vector scope.
ON / OFF
WFM TYPE
(AG-UX180 only)
Choose WFM display type.
WAVE , VECTOR, WAVE/VECTOR
WFM POSITION
(AG-UX180 only)
Set WFM display position.
TOP/LEFT / TOP/RIGHT / BOTTOM/LEFT /
BOTTOM/RIGHT
ZEBRA
Set type of light indication
(Zebra or Spot meter).
ZEBRA1 / ZEBRA2 / MARKER / OFF
3. MENU settings