104
Preparation：Preparing for Audio Input
Take the following steps to prepare the camera for connecting audio input devices.
AJ-HPX2000 can be equipped with the AJ-MC900G stereo
microphone kit (an extra-cost option).
1 Open the microphone holder.
2 Mount the microphone and tighten the clamping
screw. The microphone must be attached with the UP
mark on the microphone facing up.
3 Connect the microphone cable to the MIC IN jack on
the camera.
4 Set the AUDIO IN switch to [FRONT] depending on
the audio channel to be recorded.
1 Remove the cover to insert the wireless receiver and
secure it with the screws.
2 Set the AUDIO IN switch to [W.L.] depending on the
audio channel to be recorded.
Preparing for Audio Input
When Using the Front Microphone
Clamping Screw
MIC IN Jack
AUDIO IN
Switch
When Using a Wireless Receiver
When Using the Unislot Wireless Receiver
AJ-HPX2000P(VQT1D27-1)E.book 104 ページ ２００７年７月３０日 月曜日 午後１時３１分
To Next Page
Loading...
