Panasonic AK-HRP1000G

Connections
Set the connection setting to “Serial(AW5)” or “LAN(AW5)” in the [CONNECT SETTING] menu.
ヤヰワワユヤヵチヴユヵヵリワヨ
ヒチバチヒヒ
ヤヰワワユヤヵチヮヰュユドㄑㄖㄔㄉナ
ヤヰワワユヤヵチヮヰュユドㄑㄖㄔㄉナ
ヤヰワワユヤヵチヮヰュユドㄑㄖㄔㄉナ
ヤモヮヒヤモヮビ
ヤモヮピ
ヤモヮフヤモヮブ
ヤモヮプ
ヤモヮヘヤモヮベ
ヤモヮペ
ワヰワ
ワヰワワヰワ
ワヰワワヰワワヰワ
ヴㄆㄓㄊ㄂ㄍ
ド
モヸブ
ナ
ロモワ
ド
モヸブ
ナ
ワヰワ
When connecting, observe the following points.
Serial connection
Use a dedicated cable to connect the <CCU> connector of this unit to the <RS-422> connector of the AW-UE100.
Use a PoE injector for the power supply.
LAN connection
Connect the <LAN> connector on this unit to the <LAN LINK/ACT> connector on the AW-UE100 using a LAN cable (sold
separately).
Configure the camera IP address and port number settings of the connection destinations in [CAMERA IP SETTING] as
well.
This unit can be powered using PoE. Use a switching hub with PoE support.
Use a straight cable (category 5e or higher; up to 100 m (328.0 ft) in length) for the LAN cable (STP).
For details on switching hubs and PoE injectors that have been verified to support PoE, consult with your dealer.
- 4 -
Connecting the Unit to AW-UE100 Cameras