What to do if the Panasonic Industrial Equipment lamp won't come on?
First, ensure the lamp isn't blackened or broken. Next, check that the lamp's lead wire is securely connected and that the lamp is securely mounted. Also, verify that the magnet position has the same orientation as the system. If none of these steps work, replace the lamp and reset the cumulative use time.
What to do if the Panasonic Industrial Equipment lamp has reached its lifetime?
If the lamp has reached its lifetime, replace it and remember to reset the cumulative use time of the lamp.
General| Brand | Panasonic |
|---|---|
| Model | ANUP5204 |
| Category | Industrial Equipment |
| Language | English |
Details critical safety warnings and hazard classifications for operating the UV-Curing System.
Details all operation panel buttons, LEDs, display functions, and power controls.
Step-by-step guide for safely removing the old lamp and installing a new one.
Step-by-step guide to powering on the system and turning on the lamp.
Procedure for safely turning off the lamp and powering down the system.
Guide to setting and verifying UV intensity levels before manual irradiation.
Instructions on how to initiate and terminate manual irradiation using the shutter.
Guide to setting and verifying the irradiation time for timer-based operation.
Important safety notes and initial steps before replacing the UV lamp.
Detailed instructions for replacing the lamp and its associated lead wire.
Details safety features preventing cover detachment, overheating, overcurrent, and voltage issues.
Checks and remedies for lamp, shutter, intensity, and overheating problems.
Explanation of error warnings and procedures for resetting error status after addressing causes.
To Next Page