Select this icon to delete (cancel) or change the pre-set
Weekly Timer.
• Timer is turned OFF.
• Timer is set.
Weekly Timer
Note:
• Timer is disabled when Force Heater is turned on or Heat-Cool SW is enabled.
• If you have pre-set the Weekly Timer on 2 zones, you must repeat the same procedure with Zone 2.
Select “Yes”.
• If you select “No”, the screen will return to the Main Screen.
• Timer setup: Select Timer setup to edit the Weekly Timer.
• Timer copy: Select to copy a timer setting.
[Example of a Timer setup]
Select the day(s) which you wish to edit using buttons.
If all 6 patterns are not pre-set, this screen will be displayed.
After 1 sec delay.
1. Select pattern “1” ~ “6”.
2. Set the hour and minutes of the Timer.
3. Select ON/OFF of the Timer.
4. Select the operation mode.
• Select mode using buttons.
5. Set the temperature for both Zone 1 and 2 (if your system has the
2-Zone setting).
6. Set the Tank temperature.
1
2
3
5 6
Force Heater
Press to confirm your selection.
4
Scan to view our
video tutorial on
setting your weekly
timer.
15
AQUAREA USER GUIDE
To Next Page
Loading...
