(4) Camera Control-Auto Zoom / IR Set up by Administrator
[Admin] Page 1/2
From Control Panel Top Menu
--”Setup info”—”Admin”
Adjust “Zoom Limit”, “x22” for optical
or “x220” for digital
1. Adjust “Auto Zoom Magnification”
selecting from “1,2,3,4,5,7,10,15, or 22”
2. Adjust “Auto Zoom” Time for zoom magnification
retention time from “3,5, or 8” seconds
*Factory Initial setting:
“Zoom Limit” = “x22”
“Auto Zoom Magnification” = “10”
“Auto Zoom Time” = “3” seconds.
Select “Auto”, “Off”, “On” or “Last”
When setting “Init IR Mode” as “Auto”,
select IR Level, “Low”, or “High”
and IR Time, “10, 30, 60 or 300”
Select “Auto”, “Preset”, or “Disable”.
“Auto”: Set to auto focus when zoom ratio is changed.
“Preset”: When the soom is 3x or below, the camera
is focused at about 15m (50ft).
“Disable”: Focus is locked at a distance of about 40m
(130ft) and auto focus is disabled.
Enable or disable LPR (License Plate Recognition)
To Next Page
Loading...
