Panasonic Arbitrator-CP - Stop Recording by Trigger OFF

(7) Trigger
(b) Stop recording by Trigger OFF
Stop Recording
by Trigger OFF
Detection
(Level Signal Setting)
REC Continue Time
(Timer Setting)
Stop Recording Priority
No
(“Continue”)
1) “STOP” button is pressed.
2) Trigger OFF
1) “STOP” button is pressed.
2) Trigger OFF
3) “REC Continue Time”
“STOP” button is pressed.
1) “STOP” button is pressed.
2) “REC Continue Time”
Yes
(“1 – 90”)
No
(“Continue”)
Yes
(“1 – 90”)
Yes
(Level H or Level L)
No
(H, L, No, or B)
Yes
No
Select either of “Level H”, “Level L”
to stop recording by Trigger OFF
[Admin]
From Control Panel Top Menu
--”Setup info”—”Admin”
REC Continue
Timer Setting
Trigger
Setting
Select either of
“Continue” or “1-90”
ex. Level H
STOP REC STOP
[Remark] 1. If setting up more than 2 triggers as Level Signal, start recording when the 1
st
trigger is turned on and
stop recording when all triggers set up as Level Signal are turned off.
2. Minimum recording time is 1 minute when setting up the trigger as Level Signal.