To Next Page
B
Bryan KaiserSep 23, 2025
What to do if Panasonic aw-he40 IP Camera multiple color bands (color bars) are displayed?
- EEric RamosSep 23, 2025
Switch to the camera picture.
What to do if Panasonic aw-he40 IP Camera multiple color bands (color bars) are displayed?
Switch to the camera picture.
What to do if Panasonic aw-he40 no pictures are displayed or the pictures are disturbed?
If your Panasonic IP Camera displays no picture or the pictures are disturbed, first ensure the unit has been properly connected to the other connected devices. If the system is configured to switch the picture when the unit to be operated is selected, verify the correct unit has been selected. Also, check that the video signal setting has been selected correctly.
How to fix Panasonic IP Camera no auto focusing?
If your Panasonic IP Camera is not focusing automatically, ensure that the focus is not set to manual. Auto focusing begins as soon as the focus is set to auto. If auto focusing is difficult in certain situations, switch to the manual setting and focus manually.
What to do if Panasonic aw-he40 IP Camera pictures are too light or too dark?
If your Panasonic IP Camera images are too light or too dark, you can either select the auto setting for the iris, or manually adjust the iris by selecting the manual setting.
Why Panasonic IP Camera cannot operate using the wireless remote control?
If your Panasonic IP Camera cannot be operated using the wireless remote control, check if the remote control’s batteries have run down or have been installed with reversed polarities; if so, replace the batteries. Ensure the IR ID setting has been set correctly. Also, check for any nearby fluorescent lights or plasma monitors that might be interfering with the wireless remote control signal.
What does it mean if Panasonic aw-he40 status display lamp flashes red several times?
If the status display lamp on your Panasonic IP Camera flashes red several times, an error has occurred, such as an attempt to perform a recording operation while an SD card is not inserted. Check the event log.
Why Panasonic IP Camera no focusing in Night mode?
If your Panasonic IP Camera has no focusing in Night mode, ensure you are shooting in visible light, as the focusing position differs between visible light conditions and infrared conditions.
Why Panasonic aw-he40 IP Camera screen is excessively bright in Night mode?
If the screen is excessively bright in Night mode on your Panasonic IP Camera, the iris is set to open as a measure to prevent video spying. Adjust the brightness at the light source.
Why Panasonic aw-he40 IP Camera auto white balance adjustment (AWB) does not work?
If your Panasonic IP Camera auto white balance adjustment (AWB) does not work, check if Night mode is enabled, as AWB cannot be used in Night mode. Also, verify if the scene mode is set to [Full Auto], as ATW is performed in Full Auto mode.
How to troubleshoot Panasonic IP Camera no power?
If your Panasonic IP Camera is not powering on, check that the AC adapter is securely connected to the AC outlet and that the power plug of the AC adapter is properly connected. Also, ensure the network cable for the PoE+ (IEEE802.3at) compatible power supply device and the unit are properly connected. If the total power limit is exceeded, refer to the operating instructions for the PoE+ power supply device.
General| Image Sensor | 1/2.3-type MOS |
|---|---|
| Video Output | HDMI, IP |
| Pan/Tilt Range | Tilt: -30° to +90° |
| Power Supply | PoE+ (IEEE 802.3at) |
| Audio Input | Stereo mini jack (ø3.5 mm) |
| Network Interface | RJ-45 |
| Operating Temperature | 0°C to 40°C |
| Horizontal Resolution | 1000 TV lines (Center area) |
