FUNCTION
USER ASSIGN
For details on operations and settings, refer to the following sections in the Operating Instructions.
“USER ASSIGN”
When the unit is connected with the AW-HR140 series, you can assign the image stabilization mode (“I.S.” or “I.S.EXT”) to a user
button. When the function is assigned, the operation is as follows.
I.S.:
OFF and OIS selection
I.S.EXT:
OFF and Dynamic I.S. System (D.I.S.S) selection
CAMERA INFO
1
1 / 1
CROP
HOUSING
INFO
USER
ASSING
CAMERA
INFO
PTZ
INFO1
PTZ
INF02
2 3 4 5
6
1
2
3
4
5
1 1
ND OPT
D.ZOOM D.ZM MAX D.EXT
I.S.
OSD STAT
OFF OFF
AUDIO
D.HAZ CLR
-
D.HAZ LV
OFFND1
OFF
×
10
OFF
OFF ON ON
GENLOCK
-
-
3G SDI MIX OUT MIX IP
CAM01 : AW-HR140
0
Item Setting details
ND Sets the ND filter.
OPT Switches between the normal shooting mode and night mode.
D.ZOOM Sets the digital zoom function to ON/OFF.
D.ZM MAX Sets the maximum digital zoom magnification.
D.EXT Selects the digital extender function.
I.S. Selects the image stabilization mode.
3G SDI When the video format is 1080/59.94p or 1080/50p, selects the format for outputting 3G-SDI signals.
MIX OUT Selects ON/OFF for the display of the camera menu, status, and other information for each output image.
MIX IP Selects ON/OFF for the display of the camera menu, status, and other information that is output from the <IP
CONT> connector.
OSD STAT Sets ON/OFF for status display during AWB and ABB execution.
AUDIO Sets the audio input signal from the device connected to the audio input connector to ON/OFF.
GENLOCK This is used to adjust the horizontal phase during genlock.
D.HAZ CLR Sets the haze elimination function to ON/OFF.
D.HAZ LV Sets the level of the haze elimination.
PTZ INFO1
For details on operations and settings, refer to the following sections in the Operating Instructions.
“PTZ INFO1”
- 19 -
Menu (when AW-HR140/AW-HE130 is connected)
To Next Page
Loading...
