Panasonic AW-RP50N

42
Setup Software
 Referencing the network environment
On the “IP Address” tab, it is possible to select the IP addresses of the other AW-RP50 remote camera controllers which have
been connected in the network.
The information of the network environment created by the selected AW-RP50 units can be referenced using the “Setting” tab.
Up to five AW-RP50 units can be selected.
1 Enter the IP addresses in the AW-RP50 IP ADDRESS
boxes.
In boxes RP1 to RP5, enter the IP addresses of the AW-RP50
units whose data is to be referenced.
2 Click [Set].
3 In the list box of the “Setting” tab, select the AW-RP50
whose data is to be referenced.
The information of the network environment created by the
selected AW-RP50 unit is now displayed on the “Setting” tab.