Panasonic BL-C10 - Connecting the Camera to a Router Supporting Upnp

Installation/Troubleshooting
11
• If the camera is using a port number other than 80, the port number must be
specified at the end of the Viewnetcam URL. For example:
Using port 80: http://(Cameraname).viewnetcam.com
Using any other port: http://(Cameraname).viewnetcam.com:Port Number
1.4 Connecting the Camera to a Router
Supporting UPnP™
To allow access from the Internet with a router supporting UPnP
TM
, follow the
procedures shown in the Getting Started.
Notes
• In some routers, the UPnP
TM
feature is disabled by default. Enable your
router's UPnP
TM
feature following the router manual before you set up the
camera. See the PanasonicNetwork Camera support website at http://
panasonic.co.jp/pcc/products/en/netwkcam/ for details.
• If the maximum idle time is set in PPPoE or PPTP connection with your
ISP, disable it on the router. See the router manual for details.